Hydroponic Sytems Part 2 – Nutrient Film Technique NFT

admin 0

This system is probably the most simplest of any hydroponic system. It does not involve the use of timers to switch pumps off and on. The seeds need to be propagated first in a separate tray until they have a good enough root base to be placed in the system.

How does it work?

The equipment consists of long shallow trays which come with a long lid keeping the system enclosed. There are cut outs in the lid which is where the plants are placed. The plant sits in a plastic pot with slits to allow the roots to grow through them. They look like a smaller version of the inner pot used in flood and drain systems.

The trays are placed above a water tank and a pump connected at one end to pump water into the trays. There should be a good gradient in the trays so that the water flows down the tray and back into the water tank. Typically the gradients used are 1:30 or 1:40 this stops water pooling in the depressions caused by uneven surfaces and roots. The idea is that the roots of the plants are continuously bathed in a nutrient rich water supply and produce healthy, linear growing plants.

The name nutrient film is in reference to the thin film of roots that will eventually form on the bottom of the tray. It needs to be a very shallow stream of water with only the base of the roots submerged; this allows the rest of the root to be open to the air and get the necessary oxygen required for growth.

The systems come in different lengths which can hold different numbers of plants. Essentially you can have any length of NFT system, however the longer the system the more chance nft non fungible tokens that flow might be interrupted. Systems longer than 12 metres tend to get less growth in plants towards the end due to the nutrients in the water being taken up by the plants closer to the reservoir. However this problem can be overcome by setting up another water supply along the length of the channel.

Problems

I have mentioned a couple of issues with NFT systems such as pooling of water and nutrient reduction in the water in long system set ups. However there are a couple more.

Pump Breakdown

As NFT systems only require a small, shallow water delivery the pumps used are not very powerful. They are also on all of the time meaning that they get a lot of action over the course of the grow. This coupled with possible salt precipitation from the dissolved nutrients (especially in hard water areas) means that at some point the pump is likely to break down. If you can catch this quickly then apart from the cost of a new pump, there is no real problem to the plants. However if this goes unnoticed it means that the roots will dry out very quickly and this will affect growth.

Disease

The plant roots are constantly submerged in water and this can lead to bacterial infections such as pythuim. Pythuim is better known as root rot and can decimate your crops if it is not detected early. There are products on the market that can eradicate this if you are unlucky enough to get it, but the best way is prevention. This can be achieved by changing the water reservoir periodically and adding preventative additives to the nutrient solution.

Leave a Reply

Your email address will not be published. Required fields are marked *